You have to escape the dash, otherwise it becomes a bullet point.

You have to escape dashes, otherwise you get a bullet point.

-

versus

Source:

You have to escape dashes, otherwise you get a bullet point.

 \-

versus

 -

If you format the link as !community@instance.tld it will be a clickable link (in this case it would be !geocaching@lemmy.world).

The only issue I have with Ardour is that all plugins need to be installed separately (assuming OP hasn’t installed them already).

I recently purchased a copy of Ardour, and I have noticed that, but I have found most basic plugins can be found for free.

nothing wrong with more options :)

Options are key.

Ardour should be able to do that.

I don’t believe LMMS can do audio tracks, so Ardour would be the one to go with.

!canvas@toast.ooo (this link will open the community on the user’s own instance)

I am planning on writing a graphical interface for gphoto2 (a Linux camera remote library) which will allow for tethered shooting and some other neat things (like using a computer as an intervalometer). I might also write a web interface for it, so it will allow for using a table or phone to remote control a camera and allow the user to check on timelapses, but it will take a while to get it all to work.

I have been experimenting with using Inkscape and OpenSCAD for 3d modeling, and it seems to work for what I do, but I know quite a few people prefer a more graphical interface than OpenSCAD.

Or just go to https://lemmyverse.net/

This is a great list of communities! Nice to see that !illegallysmolbirbs@mander.xyz made it on here.

I do not believe there is any way to change it without connecting directly to the device’s circuitry, and in some widgets it may even be stored in the ROM, so a Flipper Zero would not be of much help (unless the board has some sort of programming interface you could connect to the Flipper Zero).

You might be able to use WebScreensaver.